Cablecast 4.8.4 Release Notes
=========================================================

                * Bug 3905 | Bug text moves proportionaly to any move of DSKEngine Window
-Oops!  Moving the DSKEngine window will no longer cause the bug text to move on the output.

                * Bug 3963 | LeitchTerminalCM doesn't get feedback from Harris Platinum Router
-The LeitchTerminalCM now works correctly with Harris Platinum routing switchers

                * Bug 3980 | SX Servers fail to resolve Shortcuts to media files
-SX Servers will not properly follow shortcuts to locate media files

      * Bug 4043 | Check Cablecast for depreciated license compliance
-Cablecast will now ignore all depreciated license keys

      * Bug 4058 | SX Servers playback is interrupted when Autopilot is sent
-SX Servers will no longer display a few frames of black when Autopilot is sent

      * Bug 4093 | Resume message in event viewer could be more descriptive
-The message that is logged when a show is resumed is now much more useful.  It is also logged as an information message instead of an error.

      * Bug 4096 | Enseo driver not found error is misleading
-A much more useful message is generated if the Enseo Alchemy hardware cannot be located

      * Bug 4097 | ControlModules will attempt to sync time from multiple sources
-In the unlikely event that two or more Cablecast systems exist on the network, only one of them will now be able to synchronize time.  A message is logged to the Event Viewer when this situation arises

      * Bug 4099 | End action of Stop can cause issues with Back-to-Back playback
-An end action of 'Stop' no longer causes issues when performing back-to-back playback.

      * Bug 4141 | File in use error on SX Servers
-Attempting to play a file shortly after its encoding completes will no longer cause an error

                * Bug 4143 | SXPlayerCM can get confused if two shows start at the same time
-Two shows starting at the same time will no longer cause errors on SX Servers

                                    * Bug 4200 | SierraSVSCM does not get status when using different levels
-The SierraSVSCM now uses the 'SierraSVSCMLevels' setting from the TRMS.Services.CablecastDeviceControl.exe.config file to correctly get status

      * Bug 4202 | Record runs aren't updated when changes to source run are made
-Changes to the source of a record run are now correctly propagated to the record run

      * Bug 4206 | Knox64CM does not get status from some Knox RSII Series Routing Switchers
-The Knox64CM will now try getting status using both the 'D' and the 'D0' commands.

      * Bug 4223 | SXPlayer Resumes not Logged with a negative event ID
-Events that are resumed are now logged with a negative event ID for diagnostic purposes

      * Bug 4301 | Ajax doesn't work outside of port 80
-Cablecast now plays nicely with HTTP on ports other than port 80.

                * Bug 4337 | SX Servers sometimes report various errors.
-Resolved an issue that was periodically causing various errors to be reported on SX Series Servers

      * Bug 4338 | "Can't Start Thread" errors should be more descriptive
-If an event fails to execute, the message that is logged in the Event Viewer is now much more useful

                          * Bug 4439 | SX Servers should confirm the correct version of QuickTime is installed
-The SX Servers now check the quicktime version at startup to protect against potential incompatibilities.

      * Bug 4468 | Installer now checks for .NET 3.5 SP1, does not install if it's not present
-NET 3.5 SP1 is required for Cablecast 4.8.4, FrontDoor 5.3.3 and Carousel 5.2.7.